Aeroplus UV3 2BA

HOUSE WRAP FOR OPEN JOINT CLADDING

6 MONTH
UV
EXPOSURE
W1 WATER
RESISTANCE
DENSITY
190g / m²
2 LAYER
COMPOSITE
ROLL
1,5mx50m
3mx50m

AVANTAGES
- HIGH PERMEABILITY TO WATER VAPOUR
- PERFECTLY WATERTIGHT
- COMPLIES WITH UTD 31.2
- COMPATIBLE WITH CONTINUOUS SUBSTRATES
- FOR VERTICAL WALLS COVERED IN SLATTED CLADDING FOR OPEN JOINTS UP TO 3cm AND AS 40% OF THE OPEN SURFACE
DOMAINES
D'APPLICATION
AEROPLUS UV3 2BA has the same technical properties and performances as the AEROPLUS UV3 2BA with the addition of an incorporated double adhesive strip. It is a breathable house wrap for vertical wooden walls (CF UTD 41.2) and for wooden framework constructions (cf. UTD 31.2). It meets the requirements set out in these UTDs, with a permeance lower than 0.18 m, and can be fitted in direct contact with an OSB bracing sheet. AEROPLUS UV3 2BA is a two-layer composite on a mechanically resistant black polyester film base, and is coated with a UV-stabilised monolithic coating. Its good UV resistance means it can be applied as perforated or ‘slatted’ cladding, if the gap between the slats is a maximum of 30 mm (40% as a maximum of the open surface). AEROPLUS UV3 2BA is UV-stable.
CARACTÉRISTIQUES
- Composition2 layers : PES + PU incorporated double Hotmelt adhesive strips
- Area density, EN 1849-2190 g/m² (± 10%)
- Fire resistance, EN 13501-1, EN ISO11925-2E
- Resistance to water penetration, EN 1928 Méthode AW1
- Resistance to air penetration, EN 12114<0,01m³/m² h50 Pa
- Transmission of water vapour Sd, EN ISO 125720,13 m (± 0,03)
- Tensile strength, longitudinal direction, EN 12311-1260 N/50 mm (220/300)
- Tensile strength, transverse direction, EN 12311-1250 N/50 mm (210/290)
- Elongation, longitudinal direction, EN 12311-130 % (± 15)
- Elongation, transverse direction, EN 12311-160 % (± 15)
- Nail tear resistance, longitudinal direction, EN 12310-1160 N (125/195)
- Nail tear resistance, transverse direction, EN 12310-1170 N (135/205)
- Resistance to the water column>400 cmWS
- Temperature range, EN 1109-40°C / +80°C
- UV stability>10 years
- Ageing test: 5000 hours UV (stricter test under EN 13859-2 standard)
TECHNICAL
SHEET
FEATURES
AND COMPATIBILITIES
CERTIFICATION
CE marking in accordance with EN 13859-2 standard

Produit suivant
Aerovap Hygromax

Produit précédent
Aeroplus UV3